ROBO MAZE +25 pts
Challenge: Program your robot to successfully drive through the maze.
Learning Target: I will combine the MOVE, WAIT, the DISPLAY and SOUND programming blocks to create a program that successfully completes the challenge.
I will test and modify the program as needed for success.
SUCCESS = Demonstration of each task below. Total: 25 points
Steps:
ADD A TOUCH SENSOR- PLUG INTO Port #1
* Create new program
* Name it: Maze1 and Maze2
1. Must stay within the line- not cross over.
LINE TIRES UP at START
2.Press Touch Sensor to Start the program.
(Use WAIT FOR TOUCH block)
3. STOP at STOP Sign (wait 3 seconds)
YIELD (wait 1 seconds) at the Yield sign.
3. Pay attention to speed limits: Accelerate Rabbit speed (100) and Go Turtle Slow (25).
4. Include a Display then a Sound of your choice when you land in the finish square
5. Land fully inside the finish square and spin around.